Is Dimmable: Yes
Power Source: AC
Power Generation: Motion
- Auto turn on / off by the intelligent motion sensor detected.
- Dimmable and Lighting time adjustable.
- Easy Installation with DC connector on both of the end of strip light and power adapter.
- Connection Cable total length is more than 60 inches, in case of the outlet wall plug is not so close.
- There are 2 small clips for cables management, if the cable length is excess.
Connection: Power Adapter + Motion Sensor + LED Strip Light
Clean the dust, ensure the paste place under the bed frame is free from dust before installation to avoid falling off.
Remove the 3M adhesive backing on the strip.
Stick the LED light strips on the bedside with the 3M adhesive tapes.
The Motion Sensor could only be detected in DARK environment.
Please peel off the 3M adhesive tape and heat it by the hair dryer when the environment temperature is below 68°F, then its pasting effect will be better.
Please remember to clean the installation surface first when you use the 3M adhesive tape. There is a small clip in the parcel, you have to get it to hold the end of the light strip which with the wire to avoid falling off.
LED Strip Length: 60 inches
LED quantity: 45LEDs
Operate Voltage: 12V DC
Color: Warm White 2700K
IP Grade: IP65 Waterproof
Sensor Detected Distance: 4m
Sensor Detected Angle: 100°
Lighting contined time: 30s, 130s, 380s
Input Voltage: 110V AC
Output Voltage: 12V DC
Output Current: 500mA
You may also Fancy